MacDon HC10 for D-Series - Manual (Page 93)

OPERATION
Adjusting Rear Deflector (Fluffer Shield)
WARNING
Stop engine, and remove key before making
adjustments to machine. A child or even a pet
could engage the drive.
The rear deflector (A) slows the crop exiting the conditioner
rolls, directs the flow downward, and "fluffs" the material.
To adjust the rear deflector, follow these steps:
1. For more crop control in light material, lower the
deflector by pushing down on one side of the deflector
and then on the other side.
Locking bolts (B) are
located at either end of the deflector and may be
loosened slightly.
2. For heavier crops, raise the deflector by pulling up on
one side and then on the other side.
NOTE: For even windrow formation, be sure the
deflector is not twisted.
Figure 4.40
Adjusting Deflector Fins
WARNING
Stop engine, and remove key before making
adjustments to machine. A child or even a pet
could engage the drive.
Adjustable deflector fins help to provide different swath
widths and distribution of crop across the windrow.
Angles for the short fins (A) can be adjusted by loosening
mounting bolt(s) and rotating as required. The long fins (B)
can be adjusted using the slots in the cover.
Set fins approximately parallel to side deflectors for wide
swath and adjust as required for even distribution of crop
across full width. For narrow windrow less than 70 inches
(1780 mm), remove fins.
Figure 4.41
4.9.6 Unplugging the Conditioner
To unplug the conditioner, reverse the header drive. Refer to the windrower operator’s manual for procedures on
reversing the header drive.
169254
85
Rev. D