MacDon HC10 for D-Series - Manual (Page 61)

UNLOADING AND ASSEMBLY
3.9 Installing the Forming Shield
To install the forming shield, follow these steps:
1. Position the forward end of the forming shield (A)
onto the two pins (B) located on the rear cover of the
conditioner.
Figure 3.57
2. Insert lynch pins (A) to secure forming shield to
conditioner.
Figure 3.58
3. Set forming shield side deflectors to desired width by
loosening handle (A) and moving deflector (B). Tighten
handle. Set both deflectors to approximately the same
position.
4. Loosen handles (C) and adjust fluffer shield (D) to
middle position. Tighten handles (C).
Figure 3.59
169254
53
Rev. D