3installing the rock grate, Installing the rock grate, 3 installing the rock grate – MacDon HC10 for D-Series User Manual
Page 40
Advertising
3.3
Installing the Rock Grate
To install the rock grate, follow these steps:
1.
Unpack feed deck / rock grate bundle.
2.
Position rock grate into center area of header.
3.
Lift rock grate (A), and position the rear tabs (C) so they
slide over the header leg flanges.
4.
Position the front lip (B) of rock grate (A) in front of the
bottom edge of the cutterbar, and slide forward so it
engages the cutterbar.
5.
If the header is equipped with cutterbar poly, set the
rock grate on top of the poly in front of the cutterbar,
then push down, and forward to seat the rock grate
onto the cutterbar.
Figure 3.6
6.
Ensure rock grate is pushed fully forward, and secure
with two bolts installed from underside. Tighten bolts.
Figure 3.7
169254
32
Rev. D
Advertising