MacDon HC10 for D-Series - Manual (Page 37)

3 Unloading and Assembly
To unload and assemble an HC10 Hay Conditioner, follow each of the procedures in this chapter in order.
3.1 Unloading the Hay Conditioner
CAUTION
To avoid injury to bystanders from being struck
by machinery, do not allow people to stand in
unloading area.
CAUTION
Equipment used for unloading must meet or
exceed the requirements specified below. Using
inadequate equipment may result in vehicle
tipping or machine damage.
Lifting Vehicle
Minimum Lifting
Capacity
7
2000 lb (908 kg)
Minimum Fork Length 60 inches (1524 mm)
Figure 3.1: Hay Conditioner Bundle #4798
IMPORTANT
Forklifts are normally rated for a load located 24
inches (610 mm) ahead of back end of the forks.
To obtain the forklift capacity at 48 inches (1220
mm), check with your forklift distributor.
WARNING
Be sure forks are secure before moving away from
load. Stand clear when lifting.
Figure 3.2: Feed Deck Bundle #4799
7. At 48 inches (1220 mm) from back end of forks.
169254
29
Rev. D