RaySafe Solo - Manual (Page 33)

tRAnSfeR dAtA to A CoMpUteR
to view the waveform in the RaySafe Xi View and/or transfer measured data to a pC, connect a serial cable or
Bluetooth module (option) to the communication port on the RaySafe Solo base unit.
InStAllInG RAySAfe Xi VIeW
the RaySafe Solo is delivered with a Resource Cd which contains the RaySafe Xi View software. Insert the Cd
in a pC and a menu will appear for installation. If the installation menu doesn’t appear, the RaySafe Xi View can
be installed from the Cd by accessing the “fSCommand” folder and select “Install Xiview.exe”. the software is
compatible with Windows 7, Windows Vista, Windows Xp, Windows 2000 and Windows 98Se.
during the installation you will be asked if you want to install a driver for the USB serial port adapter. If your
laptop is not equipped with a serial port and you intend to use a USB to serial adapter, please check the box to
install the driver.
there are two ways for the instrument to communicate with a pC:
• Via the RS-232 cable to the pC. If the pC has only USB ports, the supplied standard
adapter converting RS-232 to USB must be used.
• Via a Bluetooth module connected directly to the RaySafe Solo serial port. A pC with
built-in or external USB Bluetooth normally works after the required setup procedure.
SetUp of BlUetooth CoMMUnICAtIon
1. follow the instructions enclosed with the pC’s internal or external Bluetooth device.
2. Insert the Bluetooth module into the RaySafe Solo base unit’s RS-232 port and turn on the base unit.
3. Go to the Bluetooth icon in the Windows Control panel. Select a menu called “Add Bluetooth device” or
similar.
4. the pC will scan for available Bluetooth devices and will find “Xi slave”. Add this device.
5. When prompted enter the passkey for the Xi slave which is “1234”.
6. the installation procedure will finish. please note the number of the CoM port assigned to the instrument.
33
RaySafe Solo User Manual – RaySafe Solo pC kit