RaySafe Solo - Manual (Page 8)

GettInG StARted
1. Connect the detector to the base unit with one of the two (2 and 10m) cables.
2. position as required for the detector, see the following chapters.
3. turn on the RaySafe Solo (ON/OFF key, see below), and the instrument specific setup information is
displayed. In the SENSOR MENU a detector or sensor field for your application can be selected.
4. the instrument is now in MEASURE MODE and ready to measure. press STEP to scroll through measured
parameters (also possible during fluoroscopy). the last three displayed parameters will automatically show
up after the next exposure. to change setup values (SETUP MENU) such as various delays, displayed units
and other choices, press SELECT.
KeyS on the RAySAfe Solo BASe UnIt
ON/OFF: turns on the RaySafe Solo and off when in SENSOR MENU.
EXIT: exit to the previous menu.
STEP: A short press steps through available options.
SELECT: A long press selects an option.
8
RaySafe Solo User Manual – Getting Started