RaySafe i2 System - Manual (Page 10)

10
RaySafe i2 System User Manual – Using the real time display
USIng tHe ReAl tIMe dISplAy
IntRodUCtIon
the real time display is the display unit in the RaySafe i2 system. It communicates wireless with dosimeters
within radio range in order to collect, present and store dosimeter dose data.
Figure 4. The real time display.
WARNING The distance from which the real time display detects a dosimeter depends on the settings
that the service engineer made during the installation.
gettIng StARted
StARtIng tHe ReAl tIMe dISplAy
1. Connect the output connector of the power adapter to the back of the real time display,.
2. Connect the input connector to a grounded electrical outlet socket.
this will switch on the real time display.
WARNING To avoid the risk of electric shock, the real time display must only be connected to a supply
mains with protective earth.
first a start up screen will be displayed for a few seconds and after 30 seconds the system is ready to use. the
online view will display a maximum of 8 dosimeters at a time. only dosimeters that are in range of the real time
display will be displayed.