RaySafe i2 System - Manual (Page 8)

8
RaySafe i2 System User Manual – Using the cradle
USIng tHe CRAdle
Figure 3. The cradle
IntRodUCtIon
the cradle is a dock station that lets you connect a dosimeter to a computer for data read out as well as
dosimeter options writing into the dosimeter. Use the cradle in combination with the dose viewer and/or dose
manager applications.
gettIng StARted
NOTE Do not connect the cradle to the computer unless dose viewer and the cradle driver are
installed on the computer.
1. Start the dose viewer/dose manager application.
2. Connect a cradle to your computer’s USB port.
3. put a dosimeter in the cradle.
within a few seconds, dose viewer/dose manager will detect the dosimeter. this is indicated at the top of the
main window by a note “Connected to dosimeter 100001158”, where dosimeter 100001158 is an example of a
dosimeter Id.
dose viewer/dose manager will start loading the dosimeter dose history. this may take up to a few minutes.
you can follow the progress on the progress bar at the bottom of the main window.