Brother NC8100H - Manual (Page 112)

CHAPTER 11 DLC PRINTING
11-3
Windows
®
2000 Printer Setup
1. Log into Windows ® 2000 with administrative privileges. From the Start
menu, select Settings and then Printers.
2. Select Add Printer (If you have already installed a Brother printer driver,
double click the printer driver that you wish to configure and then select
Printers/Properties, select the Ports tab, Click on “Add Port” and
continue from Step 6 (ignoring steps 11-14) about installing the correct
driver).
3. Click Next.
4. Select Local Printer and make sure that “Automatically detect and install
my Plug and Play printer” is not checked.
5. Click Next
6. Select the “Create a new port:” option and highlight “Hewlett-Packard
Network Port”
7. Click Next
8. A list of available Print / Fax server MAC addresses (Ethernet addresses)
appears in the larger box under Card Address. Select the address of the
desired Print / Fax server (you can see the Ethernet address on the printer
configuration page)
You can find the node name and MAC address by printing out the printer
configuration page. Refer to the NC-8100h Quick Network Setup Guide for
information on how to print the configuration page on your Print / Fax server.
9. The selected Print / Fax server address will then appear in the smaller
box under Card Address.
10. Type in any desired name for the port (the name must not be the name of
an existing port or DOS device, such as LPT1) and click OK then on the
Printer Ports screen, click Next.
11. Select the correct driver click Next.
12. Give a name to the printer and specify if you wish to be able to print
from DOS application. Then click Next
13. Specify the share name (if you are going to share the printer).
14. Enter the Location and Comment information and click Next until you
see the “Completing the Add Printer Wizard” screen.
15. Click Finish