Brother NC8100H - Manual (Page 79)

CHAPTER 8 BIP INTERNET PRINTING INSTALLATION
8-4
Brother Internet Print
Using BRAdmin to Configure the Print / Fax
server
Skip this section if you wish to use the Print / Fax server remote console or Web
Browser to configure the Print / Fax server.
Using the BRAdmin application, you can configure the Brother Print / Fax server
using the TCP/IP protocol, or the IPX protocol.
The steps required to configure the Print / Fax server to receive print jobs from a
Windows
® 95/98//Me/NT ® 4.0/2000/XP. PC running the BIP software is as
follows:
1. Start BRAdmin.
2. Select the node name of the desired Brother Print / Fax server from the
list and double clicking on it. (the default node name is usually
BRN_xxxxxx, where "xxxxxx" is the last six digits of the Ethernet
address (MAC address)). You will be prompted for a password, the
default password is "access".
You can find the node name and MAC address by printing out the FAX/MFC’s
configuration page. Refer to the Quick Network Setup Guide for information on
how to print the configuration page on your Print / Fax server.
3. Click on the Internet tab.
4. Enter the IP address of the POP3 server (consult your network
administrator if you do not know this address).
5. Enter the mailbox name for the remote Brother Print / Fax server.
Usually this will be the first part of the E-mail address (for example, if
the E-mail address of the Print / Fax server is emailprinter@xyz, then the
mailbox name would be emailprinter).
6. Enter the password for the mailbox, if any.
7. The Print / Fax server is configured by default to poll the POP3 server
every 10 minutes. You may change this value, if desired.
8. If you have enabled notification, enter the IP address of your SMTP
server (consult your network administrator if you do not know this
address).
9. Press the OK button and save the changes. Now exit the BRAdmin
application. You have now configured the Print / Fax server to receive
print jobs.