Brother NC8100H - Manual (Page 24)

CHAPTER 2 FRONT PANEL SETUP MENU
2-1
2
21
CHAPTER TWO
Front Panel Setup Menu
LAN Main Setup Menu
The LAN menu selections allow you to setup the Brother FAX/MFC for your
network and Internet Fax configuration. Press [Menu] then press the appropriate
number for LAN, based on the selections displayed on your machine. After you
have displayed the LAN Main Setup menu, there are six main selections: 1-
Setup TCP/IP, 2-Setup Internet, 3-Setup Mail RX, 4-Setup Mail TX, 5-Setup
Relay and 6-Setup MISC. Proceed to the menu selection you wish to configure.
Please note that once you have specified a valid IP address for the machine, it is
also possible to configure many aspects of the FAX/MFC using your favorite
web browser. For added flexibility, the FAX/MFC is supplied with the BRAdmin
Professional Windows
® software, which also can be used to configure many
aspects of the NC-8100h.
1-Setup TCP/IP
This menu has eight sections: 1-Boot Method, 2-IP Address, 3-Subnet Mask, 4-
Gateway, 5-Host Name, 6-WINS Config, 7-WINS Server and 8-DNS Server.
1-BOOT METHOD
1. Press the [Menu] button to display the configuration menu.
2. Select
LAN.
3. Press [1] [1].
4. Press
! or " to select AUTO, STATIC, RARP, BOOTP or DHCP.
5. Press [Set] to accept the selection.
6. Press [Stop/Exit] to exit the configuration menu.
7. Now make sure that you power cycle the FAX/MFC.