Regency Horizon HZ54E Large Gas Fireplace - Manual (Page 42)

42
Regency Horizon HZ54E-1 Gas Fireplace
INSTALLATION
GTMF REMOTE INSTALLATION
DFBC = digital fi replace burner control
1) Remove the faceplate and glass door to access to DFBC &
battery pack tray.
2) Lift DFBC and battery pack up and out.
3) Disconnect connector from battery holder and remove from tray – (battery
holder is attached by Velcro to tray).
4) Remove the 4 AA batteries if installed, reconnect the connector to the
battery pack and put back onto Velcro strip
5) Locate the Green and White wires from the DFBC module wire harness;
connect the spade connectors from the receiver wire harness, (TH) Green
to (DFBC) Green and (TH/TP) White to (DFBC) White
6) Locate the DFC wire from the receiver wire harness and connect to th
DC supply wire from the DFBC. (insert pictures
7) Remove the hi/lo knob from the valve head, if installed, by removing
2 screws as shown below.
8) Install the stepper motor in the same location the hi/lo knob was
removed from - with 2 screws as shown below.