Regency Horizon HZ54E Large Gas Fireplace - Manual (Page 43)

Regency Horizon HZ54E-1 Gas Fireplace
43
INSTALLATION
14) Install the fan control module onto the velcro pad located on the fl oor
the unit located left of the receiver.
Fan Control Module
13) From the wire harness, plug the FCM wire into the fan control modul
9) Install 4 - AA batteries into the receiver.
11) Install the heat shield to the receiver with two screws and attach to the
fl oor of the unit with a velcro pad.
15) Plug fan control module into receptacle located on the left hand side of
unit.
16) Match the remote control to the receiver - see remote control
instructions.
17) Reverse step 1.
18) Check to ensure there are no gas leaks..
Heat shield
FCM wire
10) Plug ‘motor’ wires into the back of the receiver and bundle wires with the
wire clip - as shown below.
12 Before installing the fan control module, install the heat shield on the
control module by securing with 2 screws.