Regency Horizon HZ54E Large Gas Fireplace - Manual (Page 56)

56
Regency Horizon HZ54E-1 Gas Fireplace
INSTALLATION
21) Attach the receiver to the unit with the velcro strip. Place the receiver
in front of the ground lug on the left side of the unit - inside the bottom
frame of the unit - follow steps 15-19 to complete installation.
20) FOR GTMF INSTALLATIONS ONLY: Install the fan control module into
the unit through the open fan access panel. Plug the fan control module
into the receptacle in the unit (left side - fl oor of unit). Plug the fan into
the fan control module and connect GTMF remote (see GTMF installation
instructions in this manual).
17) Reverse Steps 8 through 5.
18) Install the fan air defl ector - it hooks to 2 brackets on to the bottom lip of
the unit, to the right of the receiver.
19) Reverse Steps 4 through 1.
Air defl ector
TO REMOVE THE FAN
1) Turn the power off.
2) Reverse the above instructions.
Maintenance: The sealed bearings are lubricated, there is no need to lu-
bricate them further. (Extra lubricant will cause more lint and dust buildup
- causing the bearings to prematurely fail).
Regular cleaning and vacuuming of the fan area will add to the life of the
motor.
IMPORTANT:
These fans collect a lot of dust from within your home. Ensure you
maintain these fan motors on a regular basis by vacuuming
the fan blades and housing using a soft brush nozzle.
Air defl ector
Bracket
FAN
RECEIVER
Top View
FCM
7”
10”
6-1/2”