Regency Horizon HZ54E Large Gas Fireplace - Manual (Page 63)

Regency Horizon HZ54E-1 Gas Fireplace
63
MAINTENANCE
HZ54E-LP UNIT
1) Loosen 6 screws that secure the burner extenders. on burner tray,
located behind the burner on either side of the pilot assembly.
2) Lift out the 2 burner tray extenders.
4) After extenders have been removed. Remove the 2 screws that
secure the burner tray, at the base of the fi rebox.
5) Slide the burner to the left and lift it out.
6) With burner removed - lift out burner tray.
Burner tray extenders
Burner tray extenders
Burner tray
Gas Inlet Line
Burner Bracket
Location of screws securing burner
10) Partially lift out valve tray.
11) Disconnect the inlet gas line.
12) Replace valve and reverse steps.
9) Remove the valve tray by undoing 12 screws.
Green Wire Orange Wire
7) Disconnect the green and orange wires from the valve.
8) Disconnect the green ground wire from the valve bracket.
Green ground wire