Regency Liberty L390PB Medium Gas Insert - Manual (Page 19)

L 390 PB-2 / HZI 390 PB-2 Direct Vent Gas Insert
19
INSTALLATION
GT REMOTE INSTALLATION
Note: GT remote control installation must be completed prior to the unit
being installed.
1. Bring the TH and TP-TH wires around back of the unit to the right side -
where the valve is located.
GT Remote Receiver Components
1 946-680 GT remote control
2. Connect the TH/TP-TH wires from the harness to the valve terminals also
marked TH/TP-TH - locations as shown below.
3. Secure cable ties to the unit as shown by inserting cable ties into round
holes. There will be a total of 4 cable ties that need to be inserted into the
holes. (2 on the back and 2 on the left side located on the lower side of
the fi rebox).
TPTH Wire
TH Wire
4. Install receiver onto backing plate with 2 screws and plug in receiver w
.
Cable Tie
Wire Clip
Left
Right
Cable Tie Cable Tie
4. Bundle excess wires - with the exception of the wire marked receiver.
Receiver wire requires enough slack to reach the front left of the unit t
be connected to the receiver.
Secure wires with cable ties installed in previous step.
Additionally secure wires with a wire clip to be installed in location show
below.
5. Connect receiver wire from the wiring harness to the back side of the
remote receiver as shown below
8. Bundle excess receiver wire using a cable tie and secure to the front le
of the fi rebox as shown below.