Telematrix SP750 - Manual (Page 24)

24
Programming Flash Timing
(Administrator)
Flash timing can be programmed for different timing options listed below.
1. Press and hold the “STORE” key for 6-seconds to enter set up.
2. Press the “STORE” key multiple times until the LCD display reads “FLASH TIME
SET”.
3. Enter the flash timing to be stored into memory using the keypad by pressing
the following keys on the keypad in the order shown. The keypad entry will be
displayed on the LCD Screen.
For 100mS press "1" "0" "0" on the keypad.
For 200mS press "2" "0" "0" on the keypad.
For 300mS press "3" "0" "0" on the keypad.
For 400mS press "4" "0" "0" on the keypad.
For 500mS press "5" "0" "0" on the keypad.
For 600mS press "6" "0" "0" on the keypad.
For 700mS press "7" "0" "0" on the keypad.
For 800mS press "8" "0" "0" on the keypad.
For 900mS press "9" "0" "0" on the keypad.
For 1000mS press "1" "0" "0" "0" on the keypad.
4. To exit the program mode, press “DISC” or continue to the end of program-
ming by pressing the “STORE” key multiple times until the display reads “All
Setup OK”.
5. To confirm the flash timing programmed in memory, repeat the Administrator
programming sequence to see flash timing display.
Programming Example for 100mS
Press “STORE” for 6 seconds, Press “STORE” again until LCD
reads “ “FLASH TIME SET”. Enter digits “100” from the keypad.
Press “STORE” to enter the timing into memory.
NOTE: The Flash Timing factory default is 600mS !
Note: Programming can
only be performed when
the phone is on-hook
!