Telematrix SP750 - Manual (Page 27)

27
Programming the Access Number into Memory
(Administrator)
In some cases, a digit or digits are required to access an outside line (i.e. 9) . The
Access Number can be programmed into the phone. This function allows the user
to automatically dial number(s) that are required prior to dialing the displayed
number.
• The number to be programmed is based on your specific area dialing require-
ments and may not be required.
• This option is not mandatory for the proper operation of the Caller ID display.
To Set Up The Access Number
1. Press and hold the “STORE” key for six seconds to enter programming.
2. Press “STORE” until the LCD display reads “ENTER ACCESS NUMBER”.
3. Enter the desired number, for example, a “9”.
4. Press the “STORE” key to enter the number into memory.
To Delete The Access Code
1. Press and hold the “STORE” key for six seconds to enter programming.
2. Press the “STORE” key until the LCD display reads “ENTER ACCESS NUMBER”.
3. Press the “DELETE” key.
4. Press the “STORE” key again to continue.
ENTER ACCESS NO
Set up pre-dialing num-
ber sequence, i.e. outside
line.
ENTER ACCESS NO.
12/01
PM
12:00
9 - - - -
NOTE: There is no need to enter PAUSE. The Call Back operation
automatically inserts a pause after the Access Code Number.
!
Note: Programming can
only be performed when
phone is on-hook
!