Telematrix SP750 - Manual (Page 30)

30
Programming Voice Mail
(Administrator)
To program the Spectrum PLUS
TM one touch “MESSAGE WAITING” speed dial
key, follow these programming instructions.
Programming Voice Mail Dialing
1. Press and hold the “STORE” key for 6-
seconds to activate Administrator mode.
2. Press the “STORE” key multiple times
until “VOICE MAIL NO.” is displayed on
the LCD screen.
3. Enter the voice mail number. The area
code is not required if AREA CODE is pro-
grammed into memory.
4. Press the “STORE” key to store the voice
mail number into the VOICE MAIL mem-
ory key.
5. Enter the “PIN NUMBER”, up to 8-digits.
The PIN characters will not be displayed.
6. Enter the “SECONDS OF WAIT?”, up to 99
seconds.
7. To exit the program mode, press “DISC”
or continue to the end of programming by
pressing the “STORE” key multiple times
until the display reads “All Setup OK”.
Test the program
After programming voice mail, test the program by
placing a voice mail into the voice mail messaging
system. Wait for the Voice Mail button to illuminate.
Then, press the key located on the base unit (when in
OFF HOOK position) and it will dial the pre-programmed
numbering sequence. The “SECONDS OF WAIT” may
need to be increased if the voice mail was not retrieved
.
Note: This feature must be turned on by your local
service provider.
VOICE MAIL NO.
12/01
PM
12:00
555-1212
PIN NUMBER
12/01
PM
12:00
- - - - - - - -
SECOND OF WAIT?
12/01
PM
12:00
05