Telematrix SP750 - Manual (Page 33)

33
To Program a Phonebook Record Manually
1. Press the “STORE” key quickly. The words
“SETUP MONTH:01” will appear (figure 1).
2. Press the “PHONEBOOK” key. The words “ENTER
NUMBER.” will appear (figure 2).
3. Next, press the numbers on the dial pad to enter
the number pattern to be stored. It is
recommended to enter the local area code in the
numbering sequence. Local area code dialing will
not occur when the AREA CODE is programmed
into setup. Using the keypad, enter the name as-
sociated with the number being programmed and
include the Flash, and/or Pause, when needed.
4. Press the “STORE” key again and the display will
read “ENTER NAME” (figure 3).
5. Using the dial pad, enter the name of the person
to be stored. See the chart on the next page for
character entries.
6. After entering the name, press the “STORE” key.
The display will read “PLEASE WAIT” (figure 4).
The memory function is now storing the entry. If
the record is already in memory, the display will
read “REPEAT PHBOOK”.
7. To store another record manually, repeat line item
1 through 6. .
8. To exit the program mode without saving, press
the “DISC” key.
Phonebook Programming
(Manual Programming of Records)
The Spectrum PLUS TM Telephone Phonebook Feature allows for 100 name and number
records for frequently dialed calls. This section describes the Phonebook program-
ming.
•
Programming must be done with the power adapter plugged into the wall.
•
Programming can only be performed with the telephone on-hook.
•
A maximum of 32-digits can be entered into ENTER NUMBER and 12-characters into ENTER NAME.
ENTER NUMBER
ENTER NAME
Set up speed dial mem-
ory locations with name
and number entries.
Check verifies correct
entry.
SETUP MONTH:01
12/01
PM
12:00
ENTER NUMBER
12/01
PM
12:00
ENTER NAME
12/01
PM
12:00
PLEASE WAIT
12/01
PM
12:00
Figure 2
Figure 3
Figure 4
Figure 1