Telematrix SP750 - Manual (Page 25)

25
Programming Pause Timing
(Administrator)
A Pause time between 1.0-seconds to 5.0-seconds can be programmed into mem-
ory. This function allows for a delayed timing for those systems requiring a different
time delay and allows the user to delay the dialing pattern of a number. This
function may be required for accessing line features provided by telephone provider
or local telephone company. A speed dial number may need to pause during its
dialing sequence to ensure proper connections.
Pause timing can be programmed for different timing options listed below.
1. Press and hold the “STORE” key for 6 seconds to enter set up.
2. Press the “STORE” key multiple times until the LCD display reads “PAUSE
TIME:3.6S”.
3. Enter the pause timing to be stored into memory using the keypad by pressing
the following keys on the keypad in the order shown. The keypad entry will be
displayed on the LCD Screen.
Examples:
For 2.0-seconds press "2" "0" on the keypad.
For 2.1-seconds press "2" "1" on the keypad.
For 3.2-seconds press "3" "2" on the keypad.
For 4.9-seconds press "4" "9" on the keypad.
4. Press the “STORE” key to enter the new pause timing value.
5. To exit the program mode, press “DISC” or continue to the end of program-
ming by pressing the “STORE” key multiple times until the display reads “All
Setup OK”.
PAUSE TIME:3.6S
12/01
PM
12:00
PAUSE TIME x.xS
Set up pause timing 1.0S
to 5.0S. Default 3.6S.
NOTE: If you require a pause time delay longer than the maximum setting of 5.0S,
stack the pauses within the dialing pattern to achieve the longer timing.
!