Basic installation, Introduction, 1 introduction – Baldor MN1940 User Manual
Page 11
www.baldormotion.com
Basic Installation 3-1
MN1940
3.1 Introduction
You should read all the sections in Basic Installation.
It is important that the correct steps are followed when installing the DSM.
This section describes the mechanical installation of the DSM.
3.1.1 Location requirements
Ensure you have read and understood the warnings and cautions in section 1.
The safe operation of this equipment depends upon its use in the appropriate environment.
The following points must be considered:
H
The DSM is designed to be mounted indoors, permanently fixed and located.
H
The DSM must be secured by the holes in the faceplate.
Because the DSM consists of two core components, a drive and a motor, attention must be
paid to the thermal specifications of both the motor and the electronics. The following
maximum temperatures apply to the DSM:
H
The DSM heat sink temperature must not exceed 85 °C (185 °F).
H
The DSM motor temperature must not exceed 100 °C (212 °F).
3
Basic Installation
3