Baldor MN1940 - Manual (Page 12)

www.baldormotion.com
3-2 Basic Installation MN1940
3.1.2 Mounting the DSM
Ensure you have read and understood the location requirements in section 3.1.1. Mount the
DSM by the four holes in the faceplate. M5 bolts or screws are recommended.
3.1.2.1 Dimensions - DSMS17
L MAX
LMAX2
58.3
(2.3)
2
(0.08)
Ø5
(0.2)
15
(0.59)
4.5
(0.18)
24
(0.94)
42.7 (1.68)
Square
31 (1.22)
Square
4 x ØM3x0.5 thread
x 3.8 (0.15) deep
Ø22 (0.87)
Flying leads
305 (12)
All dimensions shown as
mm (inches)
30.2
(1.19)
‘P’ connector option
11.2 (0.44)
P1
P2
DSM
Model
Dimensions
(mm / inches)
Weight
L
MAX
L
MAX2
(with control knob)
g / oz
DSMS17x-1A 55.9 (2.20) 70.9 (2.79) 277.8 (9.8)
DSMS17x-2A 61.7 (2.43) 76.7 (3.02) 297.7 (10.5)
DSMS17x-3A 70.4 (2.77) 85.6 (3.37) 428.1 (15.1)
Figure 1 - Package dimensions - DSMS17
Use care when installing the mounting screws on all DSMS17 models. The
mounting holes on the flange are not drilled through, so the maximum length for
screw threads into the motor flange is 3.5 mm (0.14 in). See Figure 2. The
maximum torque for the M3x0.5 screw is 9 kg·cm (7.8 lb-in).
CAUTION