Rockwell Automation 1413-ME-PEA Capacitor Bank Controller - Series B - Manual (Page 44)

Publication 1413-UM001C-EN-P - May 2006
42 Operation
Use the DAT
The data access terminal (DAT) enters the Bit mode automatically after
you apply power. Bit mode can also be selected by pressing the BIT
key. If Bit mode was already active, the DAT displays the last bit
element monitored. If Integer mode was active, the DAT displays the
first bit element, after a brief delay during which a working message
appears.
Press the INT key to select Integer mode. If Integer mode was already
active, the DAT displays the last integer element monitored. If Bit
mode had been active, the DAT displays the first integer element after
a brief delay during which a working message appears.
To view controller data, select the desired mode (Bit or Integer). Use
the up/down keys to scroll to the word or bit address. The address
and value of the selected parameter is displayed. If the parameter is
read-only, the protected indicator will light.
The DAT checks for controller faults every 10 seconds. When the DAT
detects a controller fault, the display shows FL in the element number
field and the value of the controller’s major fault word (S2:6) is
displayed in the value field.
Please refer to the section on configuration for information on using
the DAT to edit configuration parameters.
Optional PanelView 550 HMI
The optional PanelView HMI provides you with a more robust user
interface. The following screens are provided.
• Overview Summary
F1
BIT
F2
INT
ESC
ENTER
PROTECTED
01 OFF - 0