Barco R9010111 - Manual (Page 13)

3. Starting up the D-Cine Premiere DP100
3. STARTING UP THE D-CINE PREMIERE DP100
Overview
• Switching On the projector
• Starting Image Projection
3.1 Switching On the projector
How to switch On the projector
1. First, carry out the projector check up (see "Check up the D-Cine Premiere DP100", page 5).
2. Press the tumbler switch (A) in the “I” position (ON state indicated by a visible red section of the switch). (image 3-1)
Note: Ensure that the power tumbler switch on the input panel on the projector head is in the ON state
After power On switching, the projector boots up for a while (±30s) and the final status of the projector is as follows: (image 3-2,
image 3-3)
Projector Control Panel (image 3-2) Explanation
Lamp Off The lamp is OFF , indicated by the built-in Red LED ON (A).
Dowser closed The dowser is closed, indicated by the built-in Red LED ON (B).
Push button controls The last pressed button is selected, indicated by the built-in Green LED On (D).
Control panel status After boot up of the projector without (power) FAILURE detection, the status LED
changes over from Red to Green (C).
Touch screen panel The start up menu “HOME” is displayed on the screen (E).
Panel lighting Blue panel lightning is on.
Projector Cooling System Explanation
Fans All Fans as well the Exhaust are activated, starting the air ventilation in the projector.
Engine cooling The water pump in the cooling circuit is activated, starting the liquid circulation
into the engine and the radiator.
Projector Status Lights (image 3-3) Explanation
Status lights While the projector is booting up, the status light will be flashing red.
After boot up of the projector without ERROR detection, the color of the status
Lights (A) are Green. When an error is detected, the color changes to Red.
R5976907 D-CINE PREMIERE DP100 02/11/2005 9