Barco R9010111 - Manual (Page 17)

4. Cinema Operation
4. CINEMA OPERATION
Introduction
This section explains how trained operators can use the projector for presenting cinema events such as first-run movies stored an
a digital media storage device.
The digital media storage device or cinema server is connected to one of the A or B input port on the input panel.
Input Panel A B
Cinema Server
to SMPTE A or B
Image 4-1
Cinema server connection
4.1 Selecting the Cinema Source
Using the Button control panel
1. The factory button assignment to a macro is represented in illustration below: (image 4-2)
Note: Buttons 1 to 10 represent respectively pre-configured cinema displays.
2. Press the button according the cinema source to be displayed.
The assigned macro is activated resulting in a full image display according the cinema processing procedure (pre-defined by the
producers).
The button built-in LED will be on, indicating the active macro.
292A_P7_FLAT_1280
292A_P7_FLAT_1920
292A_P7_FLAT_2048
292A_P3_FLAT_1280
292A_P3_FLAT_1920
ACSAR 1
292A_P7_SCOPE_1280
292A_P7_ SCOPE _1920
292A_P7_ SCOPE _2048
292A_P3_ SCOPE _1280
292A_P3_ SCOPE _1920
ACSAR 2
ACSAR 3 ACSAR 4
Image 4-2
Pre-configured buttons
Using the Touch Screen Panel
1. Successively press touch button Home and Macro’s. (image 4-3)
First page of the stored macros (divided over 3 pages of 8 macros) is displayed (page 1/3). The macro which is active is displayed
next to the field inscription “Active”.
If the active macro is linked to one of the fourteen push buttons on the control panel, then, the corresponding LED to the button
will light up Green.
2. Press the touch button according the cinema source to be displayed.
R5976907 D-CINE PREMIERE DP100 02/11/2005 13