Barco R9010111 - Manual (Page 16)

3. Starting up the D-Cine Premiere DP100
3.2.2 Using the Touch Screen Panel
How to start image projection
1. Start lamp ignition and opening dowser with the toggle buttons on the control panel (see "Using the Button control Panel", page
11).
2. Successively press touch button Home and Macro’s. (image 3-5)
The macro menu is displayed. The macro which is active is displayed next to field with inscription “Active”.
If the active macro is linked to one of the fourteen push buttons on the control panel, then, the corresponding LED to the button
will light up Green.
3. Select the macro you desire to play by pressing the corresponding touch button.
The projector starts executing the macro actions.
Image 3-5
Touch panel menu Macro’s
About stored Macro’s
Many macro’s can be programmed with the D-Cine communicator and stored in the projector. Because the touch screen can display
maximum 8 different macro’s, the number of macro’s (if more than 8) is split over more pages.
To run through the pages, two arrow touch buttons and are provided at the bottom of the screen with in between the page
number.
Image 3-6
Macro page selection
The page numbering includes consecutively the displayed page and the number of pages, for example “page 1/3” (page 1 of 3
pages).
12 R5976907 D-CINE PREMIERE DP100 02/11/2005