Barco R9010111 - Manual (Page 46)

11. D-Cine Premiere DP100 Info
The IP overview list will be displayed. (image 11-11)
Projector IP IP address of built-in Barco controller DIM-PC.
Subnet mask subnet mask address
Default gateway Default gateway address (router address
DHCP enabled : dynamic IP address used on the projector
disabled : fixed IP address used for the projector
Note: An enabled DHCP, ALWAYS requires an installed network connection to the projector.
Without network connection, the projector goes down in network error, by which the operation
of the projector is no more guaranteed.
Image 11-10
IP projector selected Image 11-11
IP projector overview
11.3.3 IP cinema
Use the D-Cine Communicator software to setup the IP addresses.
Overview
1. Push IP Cinema. (image 11-12)
The IP overview list will be displayed. (image 11-13)
Cinema IP IP address of the cinema processing part in the projector
Host name Call name for the projector. This name is associated with the IP address.
Subnet subnet mask address
Gateway Default gateway address (router address)
DHCP enabled : dynamic IP address used on the projector
disabled : fixed IP address used for the projector
42 R5976907 D-CINE PREMIERE DP100 02/11/2005