Chapter – Rockwell Automation 1336T Master/Slave Parallel AC Drv User Manual
Page 13
1336 FORCE-5.19 – August, 2000
Chapter
2
Mounting and Wiring Your 1336
FORCE Master/Slave Drive
Chapter Objectives
Chapter 2 provides information so that you can install your 1336T
Master/Slave drive.
Important: Some of the mounting and wiring information is specific
to the individual frame sizes. This information is identified in the
1336T User Manual (1336 FORCE 5.12).
This topic:
Starts on page:
Before mounting your drive
2-2
Interconnect Cable Connection
2-2
Distance between Drive and Motor
2-3
Grounding
2-3
Encoder Setup
2-3
Common Bus
2-3
User Enables
2-3
Fault Signals
2-4
Motor Setup
2-4
Drive Enable
2-6
PLC-Requirements
2-7
!
ATTENTION: The following information is merely a
guide for proper installation. The National Electric Code
(NEC) and any other governing national, regional, or
local code will overrule this information. Allen-Bradley
cannot assume responsibility for the compliance or
noncompliance to any code, national, local, or
otherwise, for the proper installation of this drive or
associated equipment. A hazard of personal injury
and/or equipment damage exists if codes are ignored
during installation.