Rockwell Automation 1336T Master/Slave Parallel AC Drv - Manual (Page 19)

1336 FORCE-5.19 – August, 2000
Chapter
3
Startup
Chapter Objectives Chapter 3 describes the procedure for proper startup and tuning of a
1336 FORCE Master/Slave Parallel Inverter AC drive. The
procedures covered in this chapter include:
Safety Precautions
This Topic: Starts on Page:
Pre-Energization Checks 3-2
Power-On Checks 3-5
Parameter Setup 3-5
Uncoupled Motor Checks 3-10
Transistor Diagnostics - Master Drive 3-11
Motor-Phase Rotation Test - Master Drive 3-11
Voltage Phasing Verification 3-12
Transistor Diagnostics - Slave Drive 3-13
Motor Phase Rotation - Slave Drive 3-13
Rotation Test (Both Inverters) 3-13
Autotuning 3-14
Motor Inertia Test 3-15
Motor Coupled to Load Test 3-16
Application Setup 3-17
Step Response Check 3-17
System Integration 3-19
Special Commands 3-20
!
ATTENTION: Hazard of Electric Shock exists in this
drive. Power circuits are optically isolated from control
driver circuits. Power circuit components are “floating”
with respect to “ground”. Use only approved methods
of isolating test equipment when making measurements
in power circuits.
!
ATTENTION: Only qualified personnel familiar with
the 1336 FORCE AC Drive and its associated machinery
should plan and implement the installation, startup and
subsequent maintenance of the 1336 FORCE
Master/Slave drive. Failure to comply may result in
personal injury and/or equipment damage.