Rockwell Automation 1747-ACNR15 ControlNet Adapter Module User Manual - Manual (Page 13)

1 Publication 1747-UM003A-EN-P
Chapter
2
Installing Your ControlNet Adapter Module
Chapter Objectives This chapter describes the procedures for installing your ControlNet adapter
module. These include:
•
European Directive compliance
•
determining power requirements
•
setting the network address switches
•
setting the I/O chassis switches
•
installing the adapter module in the chassis
•
connecting programming terminals to the network via the network access
port (NAP)
•
powerup sequence
Compliance to European
Union Directives For general installation guidelines, see SLC 500 System Installation
Recommendations on page B-6. If this product has the CE mark it is approved
for installation within the European Union and EEA regions. It has been
designed and tested to meet the following directives.
EMC Directive
This product is tested to meet Council Directive 89/336/EEC Electromagnetic
Compatibility (EMC) and the following standards, in whole or in part,
documented in a technical construction file:
•
EN 50081-2
EMC - Generic Emission Standard, Part 2 - Industrial Environment
•
EN 50082-2
EMC - Generic Immunity Standard, Part 2 - Industrial Environment
This product is intended for use in an industrial environment.