Rockwell Automation 1747-ACNR15 ControlNet Adapter Module User Manual - Manual (Page 15)

Publication 1747-UM003A-EN-P
Installing Your ControlNet Adapter Module 2-3
Installing the Adapter
Module in the Chassis Once you’ve set the appropriate switch assemblies for your adapter module,
follow these procedures for installation.
Refer to the Industrial Controller Wiring and Grounding Guidelines, Publication
1770-4.1 for proper grounding and wiring methods to use when installing
your module.
1. Remove power from the I/O chassis before inserting (or removing) the
module.
2. Align the circuit board with the chassis card guide in the left slot.
3. Slide the module into the chassis until the top and bottom latches are
latched. To remove the module, press the releases at the top and bottom
of the module and slide it out.
4. Press firmly and evenly to seat the module in its backplane connectors.
ATTENTION
!!!!
Remove system power before removing or installing your
module in the I/O chassis. Failure to observe this warning
could damage module circuitry and injure people.
ATTENTION
!!!!
Do not force the module into the backplane connector. If
you cannot seat the module with firm pressure, check the
alignment. Forcing the module can damage the backplane
connector or the module.
Card Guide
Power
Supply
Latch