Rockwell Automation 1779-KP3R DATA HIGHWAY II User Manual
Page 23
Installing the 1779-KP3
Communication Interface
Chapter 2
2Ć7
3.
Slide the module into the chassis slot, making sure it slides along the
grove at the bottom of the slot. Press firmly until you feel it snap
into the backplane.
4.
Pull the interlock bar back into place.
5.
Restore power to the chassis.
6.
Use LIST to select additional KP3 options (see following section).
After you install the KP3 into the chassis, use the LIST option to select
additional operational KP3 parameters. You access the LIST option
through an Allen–Bradley PLC–3 Industrial Terminal (1770–T4) which
has the ability to communicate directly with your Allen–Bradley PLC–3.
Refer to the PLC–3 Controller Installation and Operations manual,
publication 1775–6.7.1, for instructions on accessing the LIST function.
You can also access LIST through Allen–Bradley 6200 Programming
Software (see the PLC–3 Programming Software User Manual for
information, publication 6200–6.5.3).
The following procedure shows you how to use LIST.
1.
Connect a T4 Industrial Terminal (1770–T4) to the PLC–3 controller.
2.
Turn the T4 terminal ON.
3.
Press the shift key and then the mode key. You receive a mode of
operation menu:
SELECT MODE OF OPERATION
1 = PLC3 TERMINAL
2 = ALPHANUMERIC TERMINAL
11005-I
4.
Press 1. You receive a blank screen with a $ sign prompt at the
bottom.
Use the LIST Option to Select
Additional KP3 Parameters