Rockwell Automation 1779-KP3R DATA HIGHWAY II - Manual (Page 24)

Installing the 1779-KP3
Communication Interface
Chapter 2
2Ć8
5. Enter the LIST function at the $ prompt by pressing the shift key and
then the list key. You receive the SYSTEM–MODE menu:
SYSTEM-MODE SCREEN
1. TEST MONITOR
2. RUN MONITOR
3. *PROGRAM LOAD
4. REMOTE ENABLE
5. SYSTEM STATUS
6. MODULE STATUS
ENTER NEXT>
11006-I
6. Select the MODULE STATUS option by typing 6 <enter>.
The MODULES menu appears, which lists all of the modules in the
PLC–3 system by catalog number, including the KP3.
7. Select 1779–KP3 from the MODULES menu by typing the number
next to it and pressing <enter>. You will receive a DATA HWY II
INTERFACE menu:
KP3 1, Node 111
Data Hwy II Interface
Chassis 0, Slot 6
1 Message Timeouts
2 Token Hold Factor
3 Set Node Mode
4 Input File List
Enter Next>
The menu above shows the 4 different options you have to choose from
within the first menu. When you choose any of these options, you will
receive another menu. The following sections describes each of these
options and the sub–menu options associated with them.