Rockwell Automation 2711C-xxxx PanelView Component HMI Terminals - Manual (Page 34)

34 Publication 2711C-UM001I-EN-P - July 2014
Chapter 2 Configuration Mode
5. Click OK within 30 seconds once the message appears to accept the
changes or the old settings are kept.
Reboot the Terminal
You can restart the terminal without having to disconnect and reapply power.
After a reset, the terminal performs a series of startup tests and then either enters
configuration mode or runs the startup application.
Follow these steps to reboot the terminal from the PanelView Explorer Startup
window.
1. Go to the PanelView Explorer Startup window.
2. Click the Terminal Settings link.
3. Click the Display/Input tab.
4. Click Reboot Terminal button.