Rockwell Automation 2711C-xxxx PanelView Component HMI Terminals - Manual (Page 85)

Publication 2711C-UM001I-EN-P - July 2014 85
Troubleshoot the System Chapter 6
Recipe 1009 Recipe Download failed. Cause: Unable to write
to /*S:0 Param1*/.
Check for:
Communication errors.
Bad data point specification.
The ingredient value written is outside the Low EU
and High EU limits of the numeric data point
assigned. (These are optional OPC defined
properties representing data point minimum and
maximum values). The ingredient value could not be
converted to the type of the data point assigned.
Recipe 1010 Recipe upload completed with errors. This message is for informational purposes. No
corrective action needed.
Recipe 1011 Recipe upload completed successfully. This message is for informational purposes. No
corrective action needed.
Recipe 1012 Recipe restore failed. Cause: Operation
cancelled.
This message is for informational purposes. No
corrective action needed.
Recipe 1013 The status data point for Recipe /*S:0 Param1*/
operation could not be written to. Data Point=
/*S:0 Param2*/
Check for:
Communication errors
Bad status data point specification
The status value written is outside the Low EU and
High EU limits of the numeric data point assigned.
(These are optional OPC defined properties
representing data point minimum and maximum
values). The status value could not be converted to
the type of the data point assigned
Recipe 1014 Recipe download failed. Cause: The value /*S:0
Param1*/ is less than the minimum value /*S:0
Param2*/ allowed for ingredient /*S:0 Param3*/
Correct the dataset value.
Recipe 1015 Recipe /*S:0 Param1*/ failed. Cause: No Selector
on display.
Add a recipe selector device to the screen.
Recipe 1016 Recipe /*S:0 Param1*/ failed. Cause: No DataSet
Selector on display.
Add a dataset selector device to the screen.
Recipe 1017 Recipe /*S:0 Param1*/ failed. Cause: No Table on
display.
Add a Recipe Table Panel device to the Screen.
Recipe 1018 Recipe /*S:0 Param1*/ operation was not started
because the system is currently busy performing
another Recipe operation.
Wait for a recipe operation to complete before
starting the next recipe operation.
Recipe 1019 Recipe /*S:0 Param1*/ failed. Cause: No recipe
selected in Selector.
Select recipe and try again.
Recipe 1020 Recipe /*S:0 Param1*/ failed. Cause: Data type
of data point /*S:0 Param2*/ is incompatible with
ingredient type of ingredient /*S:0 Param3*/.
Change the type of the ingredient to match the type
of the data point, or select a different data point
which matches the type of the ingredient.
PanelView Component Terminal Alerts
Category ID Description Corrective Action