Rockwell Automation 2711C-xxxx PanelView Component HMI Terminals - Manual (Page 56)

56 Publication 2711C-UM001I-EN-P - July 2014
Chapter 3 Install and Replace Components
Battery Replacement The C400, C600 and C1000 terminals contain a lithium battery that is intended
to be replaced during the life of the product. The battery provides battery backup
for the real-time clock. It is not used for application backup or retention.
The battery is on the back of the terminals. No special tools are required to
remove the battery cover and replace the battery.
WARNING: Only the 2711C-T4T catalog is UL Listed for Class I,
Division 2 Group A,B,C,D Hazardous Locations, certified for U.S.
and Canada.
ATTENTION: Verify that power has been removed from the terminal
prior to replacing the battery. Work in a static free environment and
wear a properly grounded electrostatic discharge (ESD) wristband.
ATTENTION: Be careful when touching any of the exposed electronic
components to prevent damage from ESD.
ATTENTION: To avoid the danger of explosion, only replace the battery
with 2711P-RY2032 or a manufacturer’s equivalent such as the
Matsushita or Duracell DL2032.
ATTENTION: For safety information on the handling of lithium
batteries, see the Guidelines for Handling Lithium Batteries,
publication
AG-5.4 .
ATTENTION: Do not dispose of battery in a fire or incinerator. Dispose
of used batteries in accordance with local regulations.
ATTENTION: At the end of its life, the used battery should be
collected separately from any unsorted municipal waste and recycled.
Battery Cover
Battery
This equipment is sensitive to electrostatic
discharge (ESD). Follow ESD prevention
guidelines when handling this equipment.
C400 Battery