Rockwell Automation 57C650 AutoMax Programming Executive Version 3.8 - Manual (Page 175)

14Ć1 On Line Menu: Transfer
14.0 ON LINE MENU: TRANSFER
Entering T" for Transfer" from the ON LINE menu allows you to
change the default path, view the contents of the default path, load
application tasks onto the rack, and save application tasks from the
rack. Sections 14.1Ć14.4 describe these options in more detail. See
figure 14.1 for the Transfer menu.
ON LINE direct C: \AMXLIB3\SYSDNR\RACK1
EscăExit
Transfer
F1 Help
Load to Rack Path
Save from Rack Files
Figure 14.1 Ć TRANSFER Menu
14.1 Changing the Default Path
You can change the default DISK:\LIBRARY\SYSTEM\RACK, or path,
by selecting P" from the TRANSFER Menu. The default path is
shown in the upper right hand corner of the screen. The current
default determines the location to which you save tasks from an
AutoMax Processor or UDC module and from which you load tasks to
a Processor or UDC module.
Note carefully that your path must be the path in which the
configuration and application task files for the rack to which you are
connected are stored. If the path is incorrect, you may load the
wrong configuration and application task files to the rack. What's
more, if you save back application tasks and configuration files, you
will write over the configuration object file in the current path. You
may also write over application tasks that have the same name. If you
copy over the configuration file, you can generate it again because
the configuration database is not overwritten.