0 - notes on installation – Rockwell Automation 57C650 AutoMax Programming Executive Version 3.8 User Manual

Page 29

Advertising
background image

3Ć1

Notes on Installation

3.0 NOTES ON INSTALLATION

This section describes what you need to know before installing the

Programming Executive software. Refer to instruction manual

J2Ć3107 for the installation procedure.

WARNING

QUALIFIED PERSONNEL MUST READ AND UNDERSTAND THE APPLICABLE

AutoMax AND DCS 5000 INSTRUCTION MANUALS IN THEIR ENTIRETY PRIOR

TO INSTALLING, ADJUSTING, OPERATING, AND SERVICING THE AutoMax

SYSTEM AND THE MACHINERY THAT IT OPERATES. FAILURE TO OBSERVE

THIS PRECAUTION COULD RESULT IN BODILY INJURY OR DAMAGE TO

EQUIPMENT.

Requirements for installing the Programming Executive:
1. Your computer must be an IBMĆcompatible 80386Ćbased (or

higher) system with at least 2MB RAM (4MB recommended) and

a 40MB hard drive.

2. A serial port must be available for communication with the

AutoMax Processor. If you want to use a serial mouse while your

computer is connected to the Processor, you will need a second

serial port.

3. The operating system on your computer must be version 5.0 or

later of MSĆDOS (or equivalent). IBM OS/2t is not supported.

4. Your computer must have V3.1 or later of Microsoft Windows

software or Windows 95. Windows must be running in enhanced

mode.

3.1

Installing the Windows Software on the

Personal Computer

Windows 3.1, 3.11, or Windows 95 must be installed on your

personal computer before you can install AutoMax Executive V3.x.

Read this section carefully before beginning to install the Windows

software. If you need additional information, refer to the Microsoft

Windows User's Guide. If Windows is already loaded on your

personal computer, go on to section 3.2.
Disk 1 of the Microsoft Windows disk set contains a program called

Setup, which guides you through the installation. It will evaluate your

computer system to determine what kind of equipment you have. It

will then copy essential Windows files onto your hard disk.
After the preliminary installation, Setup will start Windows

automatically, installing additional files, and asking you to verify and

provide information about the following:
D The directory where you want to store Windows
D The type of computer you are using
D Your monitor
D Your mouse, if any
D Your keyboard and keyboard layout

Advertising