Rockwell Automation MSR42 Curtains Configuration and Diagnostic Software Tool User Manual - Manual (Page 22)

20
Light Curtain Multi-Function Control Module User Manual
Original instructions
• Low Light Intensity (Micro 400)
• Muting (Automatic)
• Safety Override
C Safety Outputs OSSD
Using the Edit button the following parameters may be selected.
• Stop delay
• External Device Monitoring
In the lower portion of the Configuration window is a “System information” field, which gives information about design errors.
By selecting the “Configuration Control” button the corresponding configuration control document will appear in a new window ( Figure 26).
Figure 26: Configuration control document window
5.4.1.2. Basic Configuration
MSR42 (Cat. # 440R-P226AGS-NNR) control units are delivered standard with the “Basic configuration”. The characteristic of this “Basic
configuration” is described in the MSR42 user manual and is shown in the sub-tab “Basic configuration” (
Figure 27).
To set a MSR42 control unit back to the original “Basic configuration” just open the basic configuration sub-tab ( Figure 27), press “Download Default
Configuration” and follow the instructions to download these parameters (See chapter 5.5.1 on page 31).
The info output is status information only.
The output may not be used as a safety signal!