B&K AVP1030 - Manual (Page 12)

Page 10
11. FM antenna
input -
Connection for the FM antenna. 75 Ohms.
12. Tape Loop - Connections for the audio of a tape deck.
TAPE OUT- Provides a fixed level, buffered audio output for sending to a tape
player. Connect the TAPE OUT from the AVP to the TAPE IN on
the tape player.
TAPE IN - Accepts audio output from a tape player. Connect the TAPE IN
from AVP to the TAPE OUT on the tape player.
13. V1 loop - Connections for the audio of a VCR designated as VCR 1.
V1 OUT - Provides a fixed level, buffered audio output for sending to a VCR.
Connect the V1 OUT on the AVP to the AUDIO IN on the VCR.
V1 IN - Accepts audio output from a VCR. Connect the V1 IN on the AVP
to the AUDIO OUT on the VCR.
14. V2 loop - Connections for the audio of a VCR designated as VCR 2.
V2 OUT - Provides a fixed level, buffered audio output for sending to a VCR.
Connect the V2 OUT on the AVP to the AUDIO IN on the VCR.
V2 IN - Accepts audio output from a VCR. Connect the V2 IN on the AVP
to the AUDIO OUT on the VCR.
15. CTRL OUT - Output that allows you to remotely control external devices. This
output is rated at 12 VDC @ 15 mA continuous. The output goes
high (12 VDC) when the preamplifier is turned on, and low (0 VDC)
when the preamplifier is turned off. This output works with the B&K
amplifiers to remotely turn them on and off (amplifiers with the
control feature). Connect the CTRL OUT on the AVP to the CTRL
IN on the amplifier.
15. IR IN - Accepts input from external IR receptors. Connect your IR
repeater to IR IN to control the AVP preamplifier when the front IR
receiver is blocked (by cabinet door).