B&K AVP1030 - Manual (Page 35)

Page 33
 
Advanced operations
Star (
7
) operations
The AVP has incorporated some new ways to change the mode of the source inputs. In
the standard SETUP menu, the digital modes of VLD, CD ,V1 ,V2 ,TV-V3, and TUNER
are set globally and are not affected as presets are recalled. Now with the
U
(star)
operations described below, you can override the setup mode to another digital input
mode. You can also save the new mode in an A/V preset for later recall. What does all
this mean? It means you can have presets for more than one digital mode of the same
input source.
For example, you can save one CD preset that uses the standard L,R analog inputs in
direct, and save another CD preset that uses the digital input with PCM stereo.
Depending on what you want to hear at the time, you can select the appropriate preset
without having to go through the SETUP menu and surround mode changes again.
It should be noted that only the DIGITAL ON mode, when set in the SETUP menu,
allows the AVP to automatically switch over to Dolby Digital Surround Processing when
a Dolby Digital digital input is detected. This feature also provides automatic switching
back to PCM 30 seconds after a Dolby Digital signal is no longer present. Overriding
the digital mode to DIGITAL OFF defeats the automatic sensor.
Procedure
First select the preset you wish to change. We will use preset 1 for this example but the
same holds true for all presets 0-9 and A0-A9.
Press 1, then ENTER to recall preset 1.
Set the input mode by selecting one of the following:
KEYSTROKE MODE
U
(star) then 1 then 0 DIGITAL OFF
U
(star) then 1 then 1 DIGITAL ON
U
(star) then 1 then 2 DIGITAL AC-3
Save the setup to preset 1 by pressing SAVE, then 1, then ENTER.