B&K AVP1030 - Manual (Page 28)

Page 26
 
You have completed the setup procedure. Remember, you have to perform the
calibration procedure every time you change your speaker configuration.
Using presets
There are 20 A/V presets provided. Presets “0" through “9" are selected using the
numeric buttons on the remote (0-9). Pressing the “A” button first allows you to select
bank “A” presets, “A0" through “A9", using the same numeric buttons (0-9).
The preprogrammed audio/video presets let you instantly select any of the audio/video
sources along with volume level and surround mode settings. You can customize the
presets, including the preset name, for ease of operation.
Recall a preset
Using the remote control, press a number on the keypad to display the preset name.
Pressing “A” selects “bank A”. Once you press a preset number, you can then press
x
or
y
to step through all the preset names. If the AVP is off, pressing a preset number
will turn the preamplifier on, then pressing ENTER will select that preset.
Keypad Display shows Keypad Display shows
number number
0 5         
1 6   $  
2 7   %  
3 8 !   &  
4 9 "   '   
Select the desired preset then press ENTER to recall. The display will show (if you
selected preset #1):
Save a preset
A preset will save the following information in a preset for you:
Master volume, Selected input, Input mode (analog, PCM, or Dolby Digital)
Surround mode, rear volume, subwoofer volume, center channel volume, delay