Bendix Commercial Vehicle Systems BLINDSPOTTER TROUBLESHOOTING GUIDE - Manual (Page 11)

Fault Isolation Procedures
2-7
Power-Up Sequence Test, continued
Step D Procedure Condition Action
1. Key off.
2. Disconnect sensor harness J2.
3. Disconnect Operator Display Unit
from harness J1.
4. Measure resistance between
J1 pin 3 and J2 pin 3.
If resistance is between
0 and 0.3 ohms
If resistance is outside of range
Replace ODU. Go to Step E.
Replace sensor. Go to Step V.
OHMS
V A COM
1
2 3
4
ODU P1
1
2
3 4
5
6
P
ow
er
-Up Sequence T
est