Bendix Commercial Vehicle Systems BLINDSPOTTER TROUBLESHOOTING GUIDE - Manual (Page 7)

Fault Isolation Procedures
Electrical Pr
etest
2-3
Electrical Pretest, continued
Step C Procedure Condition Action
1. Key off.
2. Connect negative (-) battery
cable.
3. Key on.
4. Measure voltage
between sensor harness
J2 pin 1 and ground.
If voltage is within .5 volts
of battery voltage
If voltage is outside of
range
Test complete.
Repair power path to system.
Fuse may be blown. Reconnect all
connectors. Go to Step A.
OHMS
GROUND
V A COM
1
2
3 4
5
6