Bendix Commercial Vehicle Systems BLINDSPOTTER TROUBLESHOOTING GUIDE - Manual (Page 15)

3-3
Oper
ator Displa
y
A
udio T
est
Symptom Isolation Procedures
Operator Display Unit Audible Indictor (Buzzer) Not Functioning, continued
Step C Procedure Condition Action
1. Key off.
2. Disconnect Operator Display Unit
from harness J1.
3. Measure resistance between
display harness J1 pins
2 and 4.
If resistance is between
0 and .5 ohms
If resistance is outside of
range
Go to Step D.
Repair wiring harness.
Go to Step V.
VOLT
V A COM
ODU P1
1
2 3
4