Removal / disassembly – Bendix Commercial Vehicle Systems EB/ES BRAKES SERVICE MANUAL User Manual
Page 26
25
ES-165-7M Heavy-Duty Brake, Continued
7. Remove retaining ring and washer from drum side of both
anchor pins. Refer to Figure 21.
9. To remove upper and lower shoes, remove anchor pins with a brass
drift or a mallet. Refer to Figure 23.
8. To allow removal of anchor pins, cut lock wire and remove cap
screws from spider. Refer to Figure 22.
Figure 21. Retaining Ring and Washer Removal
Figure 22. Cap Screw Removal
Figure 23. Anchor Pin Removal
NOTE: Inspect anchor pin and bushings. If pin was seized or bushing
is grooved or worn beyond 0.031" (0.79mm), replace pin and
bushing. Always replace pins and bushings with brake reline.
10. If any noted conditions are found, drive out old anchor pin
bushings from spider. Refer to Figure 24.
Figure 24. Anchor Pin Bushing Removal
11. Clean and inspect remaining brake parts as outlined in Removal/
Disassembly section of this manual.
Removal / Disassembly
Shoe Removal