Bendix Commercial Vehicle Systems EB/ES BRAKES SERVICE MANUAL - Manual (Page 27)

26
4. To allow removal of anchor pin, cut lock wire and remove cap
screws from spider. Refer to Figure 26.
Figure 26. Cap Screw Removal
Figure 25. Retaining Ring and Washer Removal
5. Remove upper anchor pin with a brass drift or a mallet. Refer
to Figure 27.
6. Rotate upper shoe around cam end, disengage roller end from
cam, then unhook return spring from shoe and remove upper shoe.
Refer to Figure 28. Discard return spring.
Figure 27. Anchor Pin Removal
Figure 28. Shoe Removal
Shoe Removal
ES-165-7H Severe Duty Brake
WARNING: The long term effects of non-asbestos fi bers have
not been determined. Therefore, precautions should be used
when handling these materials.
See General Information / Lining Material Warning
1. Perform steps necessary for drum removal, see Removal
Disassembly - Drum Removal.
2. Remove cap screws and dustshield, if applicable.
3. Remove retaining ring and washer from drum side of each anchor
pin. Refer to Figure 25.
!
Removal / Disassembly