Bendix Commercial Vehicle Systems EB/ES BRAKES SERVICE MANUAL - Manual (Page 28)

27
7. Remove lower anchor pin to remove lower shoe.
NOTE: Inspect anchor pin and bushings. If pin was seized or
bushing is grooved or worn beyond 0.031" (0.79mm), replace pin
and bushing. Always replace pins and bushings with brake reline.
8. Drive out the old anchor pin bushings from brake shoe and
spider with a suitable driver. Refer to Figure 29.
Figure 29. Anchor Pin Bushing Removal
9. Do not remove roller from the brake shoe, unless: the roller does
not roll freely, there are fl at spots on the roller, or there is more than
0.025" play between the roller and pin.
If removal of roller is necessary, use a steel punch to drive out the
groove pin, then push the pin out of the shoe. Discard roller and pin.
Refer to Figure 30.
Figure 30. Groove Pin Removal
10. Clean and inspect remaining brake parts as outlined in Removal/
Disassembly section of this manual.
Removal / Disassembly
Shoe Removal