Bendix Commercial Vehicle Systems EB/ES BRAKES SERVICE MANUAL - Manual (Page 53)

52
Figure 78. Lower Shoe Positioning
Figure 79. Upper Shoe Positioning
Figure 80. Upper Shoe Installation
Shoe Installation
T
Figure 81. Lower Shoe and Anchor Pin Installation
T
Installation / Assembly
8. Connect a new return spring to lower shoe.
9. Position upper shoe for installation on spider (partially installed
with shoe end disengaged from cam), then connect return spring to
upper shoe. Refer to Figure 79.
10. Complete the installation of upper shoe and install anchor pin,
washers and retaining rings. Refer to Figure 80.
11. Install cap screws in spider to secure anchor pins. Tighten
screws to proper torque, see Specifi cations chart, then
lock wire. Refer to Figure 81.
12. Install dustshield. Secure with cap screws. Tighten screws to
correct torque, see Specifi cations chart.